Well, it's only been a few short hours since I posted about my end grain cutting board. But it's nearing completion! This one was a little challenging as I said in my last post, since I did some premature sanding haha! But I got everything leveled out and looking awesome (as I predicted)! I used my router to put some small grooves on the ends to hold/pick up the board. 
Let me know what you think! It's on the smaller side, around 9x7x1.5 inches. I'm pretty pleased how it turned out! Message me if you want to own this one of kind cutting board!!!
Let me know what you think! It's on the smaller side, around 9x7x1.5 inches. I'm pretty pleased how it turned out! Message me if you want to own this one of kind cutting board!!!
Here's a little sneak peak of the next two that I'm making!
- Getting the slabs glued together.
- All milled and nice and straight, used the table saw.
- Two styles using the side grain this time.
These two are going to be a lot larger than the other one. Made up of red oak, maple, and one piece of birch. As always, let me know what you think!
No comments:
Post a Comment